Re: The Singularity
Gosh, does anyone still use Acme Gridley's?? .... argh! Back in the late 1960's I was dumped with a full row of them, seven machines, turning everything from hex Gunmetal to EN32B where the tools wore out every few hours and the cross slide cam tips were breaking up due to wrong pressures set on the dead stops......... Blimey, that brings it all back.
Your final point is by far the most correct; until you have been there and seen it, you would not believe the enormous variety of failure modes for a mechanical system that has to be set by a human being that in turn has failure modes.
For those of you not familiar with the challenges of setting a multi-spindle lathe; I make one point. If you need to find employees that can do and will NEVER give up trying .... employ someone that has achieved in Multi-spindle setting. Because they have to operate in a mass production environment where a machine stopped must be back running again ASAP, (they run 24hr x 365days and never stop except for either setting, tooling or replenishing the bar feed); the setter can NEVER walk away from a problem. You have to stand there, come what may and SOLVE the problem; regardless of why it occurred; you have to achieve a working machine...... 12 hr shifts, half hour lunch, 33 mile drive to and from work. NOW, THAT is working for a living!
Originally posted by mr_fibuli
View Post
Your final point is by far the most correct; until you have been there and seen it, you would not believe the enormous variety of failure modes for a mechanical system that has to be set by a human being that in turn has failure modes.
For those of you not familiar with the challenges of setting a multi-spindle lathe; I make one point. If you need to find employees that can do and will NEVER give up trying .... employ someone that has achieved in Multi-spindle setting. Because they have to operate in a mass production environment where a machine stopped must be back running again ASAP, (they run 24hr x 365days and never stop except for either setting, tooling or replenishing the bar feed); the setter can NEVER walk away from a problem. You have to stand there, come what may and SOLVE the problem; regardless of why it occurred; you have to achieve a working machine...... 12 hr shifts, half hour lunch, 33 mile drive to and from work. NOW, THAT is working for a living!
Comment